Engineer PA-07 high-precision stripper pliers, thin, solid or braided cables and wires, Made in Japan

Engineer PA-07 high-precision stripper pliers designed to remove insulation from the ends of cables or wires. This operation allows you to expose the conductor under the insulation to make connections or for other purposes.

Engineer PA-07 pliers have special edges to cut and remove insulation without damaging the conductor.
When cutting wire or cable, it is important to use the appropriate pliers for the diameter and type of cable or wire you are cutting.           

Do not attempt to adjust the bolt with nut on both sides with 2 wrenches. This can cause the bolt joint to break. Use a hex key for fastening with a torque of less than 2 N/m!!!
 

Stripper's Hole Diameter			0.8	0.95	1.15	1.45	1.8	2.1	2.5
Applicable  Wire	AWG Conversion	Stranded	24	22	20	18	16	14	12
		Solid wire	22	20	18	16	14	(12)	(10)

When using wire stripping and cutting pliers, we recommend that you observe the following safety tips:

Always wear safety glasses to protect your eyes from particles or fragments that may fly during cutting or stripping.

Make sure the pliers are in good working order and are kept clean and sharp.

Always follow the manufacturer's recommendations regarding the use and maintenance of pliers.

Work in a well-lit environment and make sure you have enough pressure on the pliers to cut or strip effectively, but not too much pressure to damage the conductor.

Do not work with live cables or wires without proper training and protective equipment. Handling live cables can be extremely dangerous and should only be done by qualified personnel.

Characteristics:
 

• Package Contents: 1 x PA-07 Engineer Pliers
• Material: Elastomer, Special alloy steel
• Total length: 175 mm
• Protection working under voltage: No
• Green colour
• Origin: Made in Japan
• Brand: Engineer
• Dimensions: 190 x 80 x 30 mm
• Weight: 135 g